Good Mark Decals – GM066 1/100 Gray #1

$12.95

Out of Stock

Description:

ASHITA NO DECAL
ASHITA NO DECAL is removable carrier film decal.
BUT! This decal is not DRY DECAL !!
ASHITA NO in Japanese means tomorrow’s in English.
■ How to apply ASHITA NO DECAL
1. Cut off the mark to stick with a cutter, a design knife, etc.
(Note) Please do not put the edge of a cutter into the varnish portion of decal.
2 .Dip the cut-off mark in water about 30 seconds.
3. It has pasteboard by hand, shift a mark, and move to a model.
4. After tweezers etc. adjust position Push with soft cloth etc., moisture is made to absorb and it is made to stick.
5. When you exfoliate a career film, please let me dry as it is for one day.
6. Check that decal has dried completely. A Scotch tape etc. is stuck on a mark and a career film is removed slowly. Moreover, only a career film can also be raised and stripped off with a design knife etc. In a small mark, this one can be removed finely. Be careful not to attach a crack to a model and a mark in that case.
7. When paste remains after removing career film, please remove with soft cloth absorbed with water.
■ Cautions on use
・Please carry out the test which removes carrier film using an unnecessary mark before use.
・Please make it established after deciding a position where water is fully included, since decal is pasted up very strongly. However, please play any paint too much and be careful of attaching too much enough.
・Please surely stick decal. if there is a portion which has floated, an ink layer may separate.
・In case you remove a carrier film, please remove from edge carefully slowly. If it removes violently, an ink layer may separate.
・Please carry out after making it dry enough, in case a carrier film is removed.
・If a carrier film is removed in the state with inadequate dryness, an ink layer may separate.  Although dryness time can be shortened by using a drier etc. Please carry out after fully awaking, in case a carrier film is removed. An ink layer may separate.


Back to Top